You are not logged in.
Pages: 1
Hello,
I followed the steps of this guide, but I think this guide assumes that I will get a kernel in / at some point (see steps for Gummiboot).
https://wiki.archlinux.org/index.php/beginners%27_guide
However after following the steps there, I have no kernel installed.
Did I miss something obvious ?
Last edited by BlueTRin (2015-03-10 11:59:57)
Offline
Duh, I had to run 'pacstrap /mnt linux', maybe someone should edit the Beginner's guide if he has access.
Offline
The 'linux' kernel package is part of the base group, so you should have installed it
# pacstrap -i /mnt base base-devel
| alias CUTF='LANG=en_XX.UTF-8@POSIX ' |
Offline
Note that in the gummiboot configuration "/" is the root of the EFI System Partition (ESP). Also note that the "arch.conf" excerpt is only a template, modify it to your needs.
Sakura:-
Mobo: MSI MAG X570S TORPEDO MAX // Processor: AMD Ryzen 9 5950X @4.9GHz // GFX: AMD Radeon RX 5700 XT // RAM: 32GB (4x 8GB) Corsair DDR4 (@ 3000MHz) // Storage: 1x 3TB HDD, 6x 1TB SSD, 2x 120GB SSD, 1x 275GB M2 SSD
Making lemonade from lemons since 2015.
Offline
Note that in the gummiboot configuration "/" is the root of the EFI System Partition (ESP). Also note that the "arch.conf" excerpt is only a template, modify it to your needs.
Thank you to both of you, I managed to install grub but I have now another issue after booting due to the RAID 0 on the Acer S7, because it is not related to this topic I will create a new thread separately. I chose Grub because gummiboot seemed to not work too well on the S7 (maybe due to that RAID 0)
Last edited by BlueTRin (2015-03-10 14:36:04)
Offline
Pages: 1