You are not logged in.
Here's something strange: while I was installing my router I added OpenNTPd as a service for the LAN. I edited the config file and I guess I didn't pay close enough attention because apparently none of the boxes on the LAN are able to sync their system clock using the router as time server.
I've been investigating it, and here's what I've come up:
1. the firewall is set up to allow traffic from the LAN to the firewall on the NTP port (123)
[20:59:46] root@accalia:/etc/shorewall # shorewall show | grep 123
30 2280 ACCEPT udp -- * * 0.0.0.0/0 0.0.0.0/0 udp dpt:123
2. my /etc/hosts.allow is configured
sshd sshd1 sshd2 : ALL : ALLOW
ntp : ALL : ALLOW
I was using "10.0.0.0/255.255.255.240" first, but I changed it to ALL to make sure.
3. OpenNTPd is configured properly:
listen on 10.0.0.1
servers pool.ntp.org
4. OpenNTPd is running and actually listening for connections!
[21:05:58] root@accalia:/etc/shorewall # netstat -l | grep ntp
udp 0 0 accalia.begaaid.be:ntp *:*
So everything should be OK, right? WRONG! When I try to sync the clock of one of the systems on the LAN I get an error:
[21:17:43] root@venetia:/ $ ntpdate accalia.begaaid.be
26 May 21:17:44 ntpdate[27366]: no server suitable for synchronization found
And when I port probe the server, nmap tells me port 123 is closed.
A bus station is where a bus stops.
A train station is where a train stops.
On my desk I have a workstation.
Offline
you probing by ip or by domain name. if by domain..make sure that the domain resolves appropriately.
"Be conservative in what you send; be liberal in what you accept." -- Postel's Law
"tacos" -- Cactus' Law
"t̥͍͎̪̪͗a̴̻̩͈͚ͨc̠o̩̙͈ͫͅs͙͎̙͊ ͔͇̫̜t͎̳̀a̜̞̗ͩc̗͍͚o̲̯̿s̖̣̤̙͌ ̖̜̈ț̰̫͓ạ̪͖̳c̲͎͕̰̯̃̈o͉ͅs̪ͪ ̜̻̖̜͕" -- -̖͚̫̙̓-̺̠͇ͤ̃ ̜̪̜ͯZ͔̗̭̞ͪA̝͈̙͖̩L͉̠̺͓G̙̞̦͖O̳̗͍
Offline
I used both. Now, it seems that sometimes my requests do get through but sometimes they don't. This is very peculiar.
A bus station is where a bus stops.
A train station is where a train stops.
On my desk I have a workstation.
Offline