You are not logged in.
ok, go easy with me... im a complete n00b when it comes to wireless stuff...
I found my matching wireless module (zd1211), compiled and installed. loading it show it loads fine but nothing in the "used by" column (is that normal?). then i was trying the followings (i want to make it work 1st using manual commands before trying to use the Arch way):
modprobe zd1211
ifconfig wlan0 up
iwconfig wlan0 essid <myessid>
dhcpcd wlan0
after a few seconds, dhcpcd simply exists. in all the time it is running (a minute or so) no ip is shown for the wireless card in neither ifconfig or iwconfig.
what am i missing???
Thanks in advance people.
Offline
But it does show wlan0 in ifconfig and dmesg, right ?
Maybe start with configuring network-profile in /etc/network-profiles. It will guide you step by step. Take a look at IWOPTS variable in the template file I think you're missing something in your commands.
And I'm assuming you're not using WEP or WPA encryption and MAC addres list in your access point.
Offline
it's working under windows with no WEP/WPA, and that would also mean that if there's a MAC address list, the computer is on it.
Offline
modprobe zd1211 ifconfig wlan0 up iwconfig wlan0 essid <myessid> dhcpcd wlan0
After the iwconfig command above, what does iwconfig show you? For comparison, here's mine:
$ iwconfig wlan0
wlan0 IEEE 802.11-b ESSID:"hack-my-network" Nickname:"go-on-I-dare-you"
Mode:Managed Frequency:2.412 GHz Access Point: A1:B2:C3:D4:E5:6F
Bit Rate:11 Mb/s Tx-Power:18 dBm
Retry min limit:8 RTS thr:off Fragment thr:off
Link Quality=25/92 Signal level=-65 dBm Noise level=-90 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
What you're looking for is the Access Point's MAC address - if that's not there, you're not connected, and you need to make sure you're passing the right information. Does your access point have any logs? They might help you work out what's missing, if anything.
Offline
I think you're missing mode managed in ifconfig but right now I don't have an access to any of my machines with wireless cards to check details.
Offline
I think you're missing mode managed in ifconfig but right now I don't have an access to any of my machines with wireless cards to check details.
most default to managed... but murphy's law says this one doesnt.
i spoke to z4ziggy before, and it hasnt associated, there's still a null address for the AP -- I suggested some things, so we'll see what he comes back with.
Offline
thanks everyone for your replies. the problem was with the router using "channel 3" which for some reason didnt work with the client. changing it to "channel 6" made all work. then when we restored the encryption a new problem rose up, but once we changed the algo (seems iwconfig dosnt support Passphrase) all works great!
thanks again ppl.
Offline
ziggy, what make/model is your zd1211 stick? It's birthday time, and I'm thinking of getting one.
Offline
1st of all - happy birthday man!
2nd, its not my hw, it was for a friend of mine whom i have installed Arch for.
the hw is Edimax/EW-7317Ug. but you might wanna check this list for complete hw supported under linux. get the green ones ofcourse... iphitus said its not the best hw in the world, so u might wanna check out with him for what is better. all i know is that this Edimax is cheap and working...
Offline
yes happy b-day tomk
may i recommend cisco's aironet 350
i love mine it will get recognized & up by just about every live distro ive tried
in arch i find in /etc/rc.conf
#MOD_AUTOLOAD="yes"
DAEMONS=(hwd )
works best it will fire up everytime
if you use MOD_AUTOLOAD="yes"
sometimes it works mostly not
it also recognizes it as eth2 instead of eth1 which hwd does
i havent really dug a whole lot to figure this out though
just thought id throw this in
Offline
Thanks for the good wishes, z, and the info. It turns out I was wasting my time, because I had forgotten that this venerable laptop only has USB 1.1 - and I already have a perfectly good Netgear stick handling 11b.
I guess I'd better think of another birthday present .........
Offline
rayjgu3 - thanks for the recommendation. As mentioned, I'm sorted for 11b connectivity - I was only interested in zd1211 for 11g, which of course, is not possible on this machine.
I think it's fair to say that the laptop isn't the only thing getting old around here .....
Offline