Arch Linux

Mihai238

Member

Registered: 2012-05-17

Posts: 7

Wireless: TP-LINK Archer T2UH doesn't work

Device info: https://wikidevi.com/wiki/TP-LINK_Archer_T2UH

lsusb -v:

Bus 003 Device 003: ID 148f:761a Ralink Technology, Corp.

iwconfig:

ra0       Ralink STA  ESSID:""                       
          Mode:Auto  Frequency=2.412 GHz  Access Point: Not-Associated                                    
          Bit Rate:1 Mb/s                            
          RTS thr:off   Fragment thr:off             
          Link Quality=10/100  Signal level:0 dBm  Noise level:0 dBm                                      
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0                                        
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

I installed the driver from https://github.com/chenhaiq/mt7610u_wif … o_20130916.

Setting the interface up doesn't work:

sudo ip link set ra0 up
RTNETLINK answers: Operation not permitted

The strange thing is that the device worked before, but after a fresh installation of the operating system it doesn't work anymore.

Any help is greatly appreciated! Thank you!

Last edited by Mihai238 (2017-06-15 18:07:03)