You are not logged in.

#1 2018-10-19 00:46:07

rjonasz
Member
Registered: 2018-10-19
Posts: 5

xen bridged network with windows server 2016 domU

Hello,

I have an arch linux server running xen 4.11 with a bridged network adapter. Windows server 2016 is installed and running with an ip address that is on the same subnet as the arch linux dom0.  I can telnet to IIS on the windows server from dom0 but I can't reach windows from outside the data centre which hosts the server.  tracepath at work shows the route to dom0 is set.  Does anyone know what I need to do to be able to access the windows server from outside? I was able to configure the windows server using xen's vnc server.  But now that is no longer working.

Thanks!

Offline

#2 2018-10-19 01:14:58

rjonasz
Member
Registered: 2018-10-19
Posts: 5

Re: xen bridged network with windows server 2016 domU

Got vnc back.  I needed to change the port in my client.  umph

Offline

#3 2018-10-19 06:41:58

rjonasz
Member
Registered: 2018-10-19
Posts: 5

Re: xen bridged network with windows server 2016 domU

Argh, I finally found a solution. I needed to put the dom0 bridge interface in promiscuous mode and voilà, I can access IIS from home.

Offline

Board footer

Powered by FluxBB