You are not logged in.

#1 2019-03-05 19:55:12

webcapcha
Member
Registered: 2019-02-14
Posts: 167

Network interface changed after installation

After set up boot loader we need to reboot, to actually load Arch. But I figured out that network interface was changed.
I don't remember what it was, but now it's ens3, thus no internet.

I was managed to solve it with:

systemctl enable dhcpcd@ens3
ip link set ens3 up

To prevent this, is it some step that I missed before reboot, or it's just normal deal to proceed with enabling systemd service?


Ukrainian

Offline

#2 2019-03-05 19:58:46

jasonwryan
Anarchist
From: .nz
Registered: 2009-05-09
Posts: 30,426
Website

Re: Network interface changed after installation


Arch + dwm   •   Mercurial repos  •   Surfraw

Registered Linux User #482438

Offline

#3 2019-03-05 20:07:43

webcapcha
Member
Registered: 2019-02-14
Posts: 167

Re: Network interface changed after installation

By default, systemd v197 will now name interfaces following policy 1) if that information from the firmware is applicable and available, falling back to 2) if that information from the firmware is applicable and available, falling back to 3) if applicable, falling back to 5) in all other cases. Policy 4) is not used by default, but is available if the user chooses so.

And why I'm failed back to level 4? What is wrong with my ens3?


Ukrainian

Offline

#4 2019-03-05 20:15:32

jasonwryan
Anarchist
From: .nz
Registered: 2009-05-09
Posts: 30,426
Website

Re: Network interface changed after installation

webcapcha wrote:

And why I'm failed back to level 4? What is wrong with my ens3?

Read dmesg and see what is actually happening.


Arch + dwm   •   Mercurial repos  •   Surfraw

Registered Linux User #482438

Offline

#5 2019-03-05 20:25:07

webcapcha
Member
Registered: 2019-02-14
Posts: 167

Re: Network interface changed after installation

Ah, not sure that I can find dmesg old logs...


Ukrainian

Offline

#6 2019-03-05 20:35:55

loqs
Member
Registered: 2014-03-06
Posts: 19,103

Re: Network interface changed after installation

ens3 looks to me to be:

2. Names incorporating Firmware/BIOS provided PCI Express hotplug slot index numbers (example: ens1)

Do you mean the name in the live media was using:

4. Names incorporating the interfaces's MAC address (example: enx78e7d1ea46da)

Offline

#7 2019-03-05 20:38:12

webcapcha
Member
Registered: 2019-02-14
Posts: 167

Re: Network interface changed after installation

In live media it was eth0


Ukrainian

Offline

#8 2019-03-05 21:22:51

Morn
Member
Registered: 2012-09-02
Posts: 886

Re: Network interface changed after installation

webcapcha wrote:

In live media it was eth0

See https://wiki.archlinux.org/index.php/Ne … face_names

Offline

Board footer

Powered by FluxBB