You are not logged in.
Pages: 1
I have installed NetworkManager, iw, dialog and wpa_supplicant. I have enabled NetworkManager using
sudo systemctl enable NetworkManagerI have also disabled existing services using
sudo systemctl disable dhcpcd@enp4s0.servicesudo systemctl disable dhcpcd@enp6s0.servicesudo systemctl disable netctl-auto@wlp5s0.serviceI have rebooted but when I enter this command I
sudo wifi-menu wlp5s0I can enter the CLI but when I select the network and press enter I get the following output which I do not fully understand
Job for netctl@wlp5s0\x2dVOO\x2d731305.service failed because the control process exited with error code.
See "systemctl status "netctl@wlp5s0\\x2dVOO\\x2d731305.service"" and "journalctl -xe" for details.I am not sure if this service is supposed to be enabled or disabled for NetworkManager to work so I tried both using
sudo systemctl disable netctl@wlp5s0\\x2dVOO\\x2d731305.servicesudo systemctl enable netctl@wlp5s0\\x2dVOO\\x2d731305.servicebut trying to enable this service gives out this error, which I guess means it's not supposed to be enabled
The unit files have no installation config (WantedBy=, RequiredBy=, Also=,
Alias= settings in the [Install] section, and DefaultInstance= for template
units). This means they are not meant to be enabled using systemctl.
Possible reasons for having this kind of units are:
• A unit may be statically enabled by being symlinked from another unit's
.wants/ or .requires/ directory.
• A unit's purpose may be to act as a helper for some other unit which has
a requirement dependency on it.
• A unit may be started when needed via activation (socket, path, timer,
D-Bus, udev, scripted systemctl call, ...).
• In case of template units, the unit is meant to be enabled with some
instance name specified.Here is the out put of
ip link1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp4s0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DEFAULT group default qlen 1000
link/ether 70:85:c2:5d:90:c7 brd ff:ff:ff:ff:ff:ff
3: enp6s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP mode DEFAULT group default qlen 1000
link/ether 70:85:c2:5d:90:c9 brd ff:ff:ff:ff:ff:ff
4: wlp5s0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DORMANT group default qlen 1000
link/ether b2:71:e5:d9:60:a4 brd ff:ff:ff:ff:ff:ffand here is the output of
systemctl --type=service UNIT LOAD ACTIVE SUB DESCRIPTION
avahi-daemon.service loaded active running Avahi mDNS/DNS-SD Stack
bluetooth.service loaded active running Bluetooth service
dbus.service loaded active running D-Bus System Message Bus
getty@tty1.service loaded active running Getty on tty1
gssproxy.service loaded active running GSSAPI Proxy Daemon
kmod-static-nodes.service loaded active exited Create list of required static device nodes for the current kernel
lvm2-lvmetad.service loaded active running LVM2 metadata daemon
lvm2-monitor.service loaded active exited Monitoring of LVM2 mirrors, snapshots etc. using dmeventd or progress polling
● netctl@wlp5s0\x2dVOO\x2d731305.service loaded failed failed Networking for netctl profile wlp5s0-VOO-731305
NetworkManager-dispatcher.service loaded active running Network Manager Script Dispatcher Service
NetworkManager-wait-online.service loaded active exited Network Manager Wait Online
NetworkManager.service loaded active running Network Manager
nmb.service loaded active running Samba NMB Daemon
org.cups.cupsd.service loaded active running CUPS Scheduler
polkit.service loaded active running Authorization Manager
rpc-statd-notify.service loaded active exited Notify NFS peers of a restart
rpcbind.service loaded active running RPC Bind
rtkit-daemon.service loaded active running RealtimeKit Scheduling Policy Service
smb.service loaded active running Samba SMB Daemon
sshd.service loaded active running OpenSSH Daemon
systemd-fsck@dev-disk-by\x2dpartuuid-027bd5e0\x2d01.service loaded active exited File System Check on /dev/disk/by-partuuid/027bd5e0-01
systemd-journal-flush.service loaded active exited Flush Journal to Persistent Storage
systemd-journald.service loaded active running Journal Service
systemd-logind.service loaded active running Login Service
systemd-modules-load.service loaded active exited Load Kernel Modules
systemd-random-seed.service loaded active exited Load/Save Random Seed
systemd-remount-fs.service loaded active exited Remount Root and Kernel File Systems
systemd-sysctl.service loaded active exited Apply Kernel Variables
systemd-timesyncd.service loaded active running Network Time Synchronization
systemd-tmpfiles-setup-dev.service loaded active exited Create Static Device Nodes in /dev
systemd-tmpfiles-setup.service loaded active exited Create Volatile Files and Directories
systemd-udev-trigger.service loaded active exited udev Coldplug all Devices
systemd-udevd.service loaded active running udev Kernel Device Manager
systemd-update-utmp.service loaded active exited Update UTMP about System Boot/Shutdown
systemd-user-sessions.service loaded active exited Permit User Sessions
udisks2.service loaded active running Disk Manager
user-runtime-dir@1000.service loaded active exited User Runtime Directory /run/user/1000
user@1000.service loaded active running User Manager for UID 1000
wpa_supplicant.service loaded active running WPA supplicant
LOAD = Reflects whether the unit definition was properly loaded.
ACTIVE = The high-level unit activation state, i.e. generalization of SUB.
SUB = The low-level unit activation state, values depend on unit type.
39 loaded units listed. Pass --all to see loaded but inactive units, too.
To show all installed unit files use 'systemctl list-unit-files'.As you can see netctl@wlp5s0\x2dVOO\x2d731305.service failed but I do not know what to do.
Last edited by epistularum (2019-04-07 17:30:05)
Offline
Netctl which provides wifi-menu is not NetworkManager the two conflict.
Please pick one and disable the other.
Offline
wifi-menu is for netctl and yes it and any services it handles should not be used while having networkmanager enabled. Use a networkmanager front end instead.
Offline
If you want a terminal user interface, NetworkManager has nmtui.
Offline
Netctl which provides wifi-menu is not NetworkManager the two conflict.
Please pick one and disable the other.
wifi-menu is for netctl and yes it and any services it handles should not be used while having networkmanager enabled. Use a networkmanager front end instead.
If you want a terminal user interface, NetworkManager has nmtui.
Thank you very much! I have disabled netctl and I am now able to connect to my wifi. For some reasons I thought that the command "wifi-menu" was for NetworkManager, excuse the stupid question.
Offline
Pages: 1