You are not logged in.

#1 2006-08-21 18:08:26

shuthdar
Member
From: Latvia
Registered: 2006-08-09
Posts: 31

turboprint - why doesn't work? [solved]

hi all,

i'm triying to make my Canon PIXMA MP110 work with arch (it's a multidevice, but i don't even hope to make it fully functional under linux - printing will be enough)

i connect it via usb. dmesg follows:
usb 1-1: new full speed USB device using uhci_hcd and address 3
usb 1-1: configuration #1 chosen from 1 choice
drivers/usb/class/usblp.c: usblp0: USB Bidirectional printer dev 3 if 1 alt 0 proto 2 vid 0x04A9 pid 0x1700

i set it to /dev/usb/lp0 in xtpsetup, it displays that printer is started but when i try to print testpage, it writes "Printer not connected; will retry in 30 seconds..." and this message stays all the time sad

how could i diagnose what happens?

Offline

#2 2006-08-21 19:46:23

whompus
Member
From: Durham. UK
Registered: 2005-08-09
Posts: 245

Re: turboprint - why doesn't work? [solved]

I sometimes had to try a different device before I could get my canon i965 to work correctly and keep swapping it around, but had no problems since version 1.94-4

My device is shown as usb://canon/i965 not sure if your device needs to be similar

Offline

#3 2006-08-21 20:19:51

shuthdar
Member
From: Latvia
Registered: 2006-08-09
Posts: 31

Re: turboprint - why doesn't work? [solved]

yeah, i changed it to usb://Canon/MP110 and it works now! thx!

Offline

Board footer

Powered by FluxBB