You are not logged in.
Hey there. I've got my install setup but for some reason when running Cadence, in the configuration the input and output lists don't populate. All I get is 'none'. It's worked before with Arch, so I know it's not the hardware. Maybe I'm missing something? I've installed the jack2 package, as well as python-dbus, alsa-libs and everything else I could find that seemed relevant in the Professional Audio wiki page.
Any ideas? Thanks!
Last edited by marmalade (2020-02-06 03:21:52)
Offline
Delete the old configuration files in ~/.config - both Cadence and jack directories - and see if that helps. It did for me.
Offline
This worked. Also check to make sure the alsa-firmware package is installed.
Last edited by marmalade (2020-02-06 03:20:47)
Offline