You are not logged in.
Few months ago, using ndiswrapper 1.21 with beyond kernel and Rt2500 drivers I was able to set up wireless connection to my router.
Now I need to go wireless again, but this time something wierd is happening.
I`ve inserted Belkin PCI card, loaded ndiswrapper module, ndiswrapper -l told me that hardware is present, I can use iwlist to scan for wireless networks, etc, however, when trying to `ifconfig wlan1 up`, ifconfig hangs and refuses to be killed. It`s using up all system resources. I can`t even properly reboot the system, it gets stuck at stopping daemons.
Dmesg:
pccard: CardBus card inserted into slot 0
ndiswrapper version 1.31 loaded (preempt=yes,smp=yes)
ndiswrapper: driver wn6201 (Arcadyan Technology Corportation,01/10/2005,4.0.0.140) loaded
ndiswrapper (NdisMAllocateMapRegisters:879): Windows driver wn6201 requesting too many (256) map registers
ndiswrapper: using IRQ 7
wlan0: ethernet device 00:14:85:26:11:43 using serialized NDIS driver: wn6201, version: 0x40000, NDIS version: 0x501, vendor: '', 168C:0013.5.conf
wlan0: encryption modes supported: WEP; TKIP with WPA, WPA2, WPA2PSK; AES/CCMP with WPA, WPA2, WPA2PSK
ndiswrapper (set_scan:1179): scanning failed (C0010011)
ndiswrapper: driver rt2500 (Ralink Technology, Inc.,06/10/2004, 2.02.06.0000) loaded
PCI: Enabling device 0000:04:00.0 (0000 -> 0002)
PCI: Setting latency timer of device 0000:04:00.0 to 64
ndiswrapper: using IRQ 11
sky2 0000:02:00.0: pci express error (0x100000)
sky2 0000:02:00.0: pci express error (0x100000)
sky2 0000:02:00.0: pci express error (0x100000)
wlan1: ethernet device 00:11:50:90:04:f2 using NDIS driver: rt2500, version: 0x20001, NDIS version: 0x500, vendor: 'IEEE 802.11g Wireless Card.', 1814:0201.5.conf
wlan1: encryption modes supported: WEP; TKIP with WPA; AES/CCMP with WPA
usbcore: registered new interface driver ndiswrapper
Offline