You are not logged in.
I'm attempting to get a Microtek ScanMaker V300 installed on my laptop. I've read the man sane-microtek2 but have great difficulty interpretting man pages at the best of times.
I have a port listed as /dev/parport0 at 0x378, or /dev/lp0 but no /dev/scanner or /dev/sg(x)
Being hardware illiterate I'm at a loss. Seems to have something to do with scsi emulation ??. Just how is the device created.
Any help appreciated (BTW Kernel 2.6.17 sane synced up to date).
The file /etc/sane.d/microtec2.conf exists in the filesystem.
Where to start?
Richard
Offline