Arch Linux

loserveg

Member

From: Pittsburgh, Pa

Registered: 2006-12-22

Posts: 45

newtork startup

hi,

i'm having a problem with my newtork card.

the thing is, i have on built in on the motherboard which is not functioning or wired into, and a separate card which is wired into...

the problem is when i installed arch the working card was labeled eth1, worked fine the whole time. then when i rebooted it switched to eth0, not sure why.  so every 1-3 reboots i do, the cards decide to switch and i have to go into rc.conf and change that all around.

so my question is, can i make this stop happening?

thanks

Last edited by loserveg (2007-02-21 03:21:04)

Snowman

Developer/Forum Fellow

From: Montreal, Canada

Registered: 2004-08-20

Posts: 5,212

Re: newtork startup

http://wiki.archlinux.org/index.php/Ude … _Each_Boot