You are not logged in.
I have a D-Link DWL-G510, AR5005G chipset. I installed the madwifi drivers and got my card detected, but I'm not able to connect to my router. I believe it's just a problem with the config files, but I'm pretty new to this so I'm not sure what needs to be done. I do have a working ethernet card which I'm using to post this write now; I just can't connect wirelessly.
I would prefer to use WPA or WPA2 if possible, but I can disable it if needed. I just want to get it working right now.
lo no wireless extensions.
eth0 no wireless extensions.
wifi0 no wireless extensions.
ath0 IEEE 802.11g ESSID:"*myessidremoved*" Nickname:""
Mode:Managed Frequency:2.442 GHz Access Point: Not-Associated
Bit Rate:1 Mb/s Tx-Power:31 dBm Sensitivity=0/3
Retry:off RTS thr:off Fragment thr:off
Power Management:off
Link Quality=23/94 Signal level=-73 dBm Noise level=-96 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
MODULES(natsemi ath_pci)
HOSTNAME="hermes"
lo="lo 127.0.0.1"
eth0="eth0 192.168.1.14 netmask 255.255.255.0 broadcast 192.168.1.14"
ath0="ath0 192.168.1.14 netmask 255.255.255.0 broadcast 192.168.1.14"
INTERFACES=(lo eth0 ath0)
gateway="default gw 192.168.1.1"
ROUTES=(gateway)
DAEMONS=(syslog-ng network netfs crond hplip cups kdm)
wlan_ath0="ath0 essid *myessidremoved* channel 11 key s:*mykeyremoved*"
WLAN_INTERFACES=(ath0)
Offline