You are not logged in.
from hwd -s
Ethernet : NetLink BCM5906M Fast Ethernet PCI Express module:tg3
the problem is that my ethernet works only when i boot into the Arch Linux Fallback, in the normal boot it doesn't work.
ifconfig only shows the lo
ifconfig eth0 shows the usual data, like Bcast, Mask, inet addr, etc, etc,
but ifconfig eth0 up shows
SIOCSIFFLAGS: No such file or directory.
also while boot up it shows starting network and then SIOCSIFFLAGS error............and once again while shutdown
/etc/rc.d/network restart shows
Stopping Network
SIOCDELRT: No such process
Starting Network
SIOCSIFFLAGS: No such file or directory
SIOCADDRT: No such process
please help me on this.
Offline
The only difference between the fallback and the usual boot is that initcpio might contain different modules (that's the phase after kernel loads and before the "init" messages start to appear). The differences are created if you edit the hooks/modules in /etc/mkinitcpio.conf. Have a look there. After you edit the file, you should regenerate the images via '/sbin/mkinitcpio -p kernel26' as root.
Offline
Offline