You are not logged in.
Hello althogether... just set up uvesafb on my machine and have some strange problems...
While booting my screen blanks out and says "signal not found". A common problem for my monitor, but i thought uvesafb maybe handles it better than vga=xxx.
anyway... blindly i type startx, which starts X of course. Now when i end X again, uvesafb is there in all its beauty...
any explanation or hints how to make it appear instantly? cause having to run X before is kinda useless
He hoped and prayed that there wasn't an afterlife. Then he realized there was a contradiction involved here and merely hoped that there wasn't an afterlife.
Douglas Adams
Offline
for completness:
uvesafb: ATI Technologies Inc., V280, 01.00, OEM: ATI RADEON 9200, VBE v2.0
uvesafb: protected mode interface info at c000:54a1
uvesafb: pmi: set display start = c00c5535, set palette = c00c5581
uvesafb: pmi: ports = c010 c016 c054 c038 c03c c05c c000 c004 c0b0 c0b2 c0b4
uvesafb: no monitor limits have been set, default refresh rate will be used
uvesafb: VBE state buffer size cannot be determined (eax=0x0, err=0)
uvesafb: scrolling: ywrap using protected mode interface, yres_virtual=2560
Console: switching to colour frame buffer device 128x48
uvesafb: framebuffer at 0xd8000000, mapped to 0xe0880000, using 10240k, total 131072k
fb0: VESA VGA frame buffer device
He hoped and prayed that there wasn't an afterlife. Then he realized there was a contradiction involved here and merely hoped that there wasn't an afterlife.
Douglas Adams
Offline