You are not logged in.
Running arch duke with hp psc2210 printer. Everything was working fine till I tried to add samba for having other computers use the same printer. Now I can't even run a test page. it appears everything in cups printer manager is unchanged. I went to cups wiki and started troubleshooting with the following
[root@cmehil andrew]# tail /var/log/messages.log
Jul 6 00:12:42 gconfd (andrew-9098): Exiting
Jul 6 07:28:07 gconfd (andrew-14343): starting (version 2.20.1), pid 14343 user 'andrew'
Jul 6 07:28:07 gconfd (andrew-14343): Resolved address "xml:readonly:/etc/gconf/gconf.xml.mandatory" to a read-only configuration source at position 0
Jul 6 07:28:07 gconfd (andrew-14343): Resolved address "xml:readwrite:/home/andrew/.gconf" to a writable configuration source at position 1
Jul 6 07:28:07 gconfd (andrew-14343): Resolved address "xml:readonly:/etc/gconf/gconf.xml.defaults" to a read-only configuration source at position 2
Jul 6 07:57:11 cmehil python: hp-check[14699]: warning: Not installed.
Jul 6 07:57:11 cmehil python: hp-check[14699]: warning: NOT FOUND! This is an OPTIONAL dependency. Some HPLIP functionality may not function properly.
Jul 6 07:57:11 cmehil python: hp-check[14699]: warning: NOT FOUND! This is an OPTIONAL dependency. Some HPLIP functionality may not function properly.
Jul 6 07:57:11 cmehil python: hp-check[14699]: warning: NOT FOUND! This is an OPTIONAL dependency. Some HPLIP functionality may not function properly.
Jul 6 07:57:13 cmehil python: hp-check[14699]: warning: Device URI: (Makeuri FAILED)
I tried going to gconf manual but could not understand it. and I checked for python and found
[root@cmehil andrew]# pacman -Q python
python 2.5.1-1
I have not finished samba yet because I am still looking things up as I try to configure it properly. Do I need to delete samba till it is written down and ready to install at one time or did I mess something else up?
Offline