You are not logged in.
Hi all!
I've installed Archlinux few days ago after many years with Ubuntu. I could configure network with no problems using networkmanager daemon. I could connect by wired connection or wifi using madwifi driver.
Today wifi connection can't connect to any net. Network seems be up but scanning fails.
[sjovani@pcsjovani ~]$ iwlist ath0 scan
ath0 No scan results
[sjovani@pcsjovani ~]$ ifconfig -a
ath0 Link encap:Ethernet HWaddr 00:1B:9E:7B:49:98
inet6 addr: fe80::21b:9eff:fe7b:4998/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
eth0 Link encap:Ethernet HWaddr 00:A0:D1:8D:2E:1B
inet addr:192.168.1.36 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::2a0:d1ff:fe8d:2e1b/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1279 errors:0 dropped:0 overruns:0 frame:0
TX packets:1409 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:985674 (962.5 Kb) TX bytes:304058 (296.9 Kb)
Interrupt:17 Base address:0x8000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:64 errors:0 dropped:0 overruns:0 frame:0
TX packets:64 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4057 (3.9 Kb) TX bytes:4057 (3.9 Kb)
wifi0 Link encap:UNSPEC HWaddr 00-1B-9E-7B-49-98-00-00-00-00-00-00-00-00-00 -00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:1199 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:195
RX bytes:0 (0.0 b) TX bytes:51722 (50.5 Kb)
Interrupt:18
I think the problem has came after configure arch to use splashy, but I don't know...
Any solution?
Thanks!!
EDIT: Solved blacklisting ath5k module. Thanks.
Last edited by lesergi (2008-07-10 11:37:16)
Offline