You are not logged in.

#1 2008-10-21 17:46:13

uorbe001
Member
Registered: 2008-04-11
Posts: 27

[SOLVED]Gnome-do refuses to work

Hi, yesterday I upgraded gnome to 2.24 and gnome-do was unable to launch any app, it seems it didn't find them, so today I have removed ~/.local/share/gnome-do and ~/.config/gnome-do and unsinstaled gnome-do. After that I ave just done a clean installation for gnome-do and now I can't get it started... this is what it reports:

** (/usr/lib/gnome-do/Do.exe:6337): WARNING **: The following assembly referenced from /usr/lib/gnome-do/Do.exe could not be loaded:
     Assembly:   gconf-sharp    (assemblyref_index=12)
     Version:    2.20.0.0
     Public Key: 35e10195dab3c99f
The assembly was not found in the Global Assembly Cache, a path listed in the MONO_PATH environment variable, or in the location of the executing assembly (/usr/lib/gnome-do).


** (/usr/lib/gnome-do/Do.exe:6337): WARNING **: Could not load file or assembly 'gconf-sharp, Version=2.20.0.0, Culture=neutral, PublicKeyToken=35e10195dab3c99f' or one of its dependencies.

Unhandled Exception: System.TypeLoadException: A type load exception has occurred.

Anyone has a clue? I have the sistem (x86_64) fully upgraded right now... Thanks!

Last edited by uorbe001 (2008-10-21 20:58:17)

Offline

#2 2008-10-21 18:51:06

flowheat
Member
From: Pittsburgh, PA
Registered: 2008-09-23
Posts: 94

Re: [SOLVED]Gnome-do refuses to work

Check out my thread over here -> http://bbs.archlinux.org/viewtopic.php?id=57161

I had the exact same problem.  You just need to rebuild gnome-do from ABS.

Offline

#3 2008-10-21 20:57:59

uorbe001
Member
Registered: 2008-04-11
Posts: 27

Re: [SOLVED]Gnome-do refuses to work

flowheat wrote:

Check out my thread over here -> http://bbs.archlinux.org/viewtopic.php?id=57161

I had the exact same problem.  You just need to rebuild gnome-do from ABS.

Thanks! that worked!

Offline

#4 2008-10-23 10:43:26

uastasi
Member
From: Salento - Italy
Registered: 2007-11-27
Posts: 247

Re: [SOLVED]Gnome-do refuses to work

Gnome-do works after abs recompiling, but I can't install Files and Folders plugin on arch i686.
I have recompiled mono-addins with abs, then removed ~/.local/share/gnome-do/ folder but the problem still remains.
If I run gnome-do --debug on terminal this is the error message

Installing "Do.File,1.4" addin...
The following add-ins will be installed:
 - Files and Folders v1.4
Installing Files and Folders v1.4


Assembly not found: gconf-sharp, Version=2.20.0.0, Culture=neutral, PublicKeyToken=35e10195dab3c99f
WARNING: [Do.File,1.4] Could not load some add-in assemblies: The classes in the module cannot be loaded.

Any suggestions? roll


Till the last battle, till the last bottle.
aur - twitter

Offline

#5 2008-10-23 19:09:10

uorbe001
Member
Registered: 2008-04-11
Posts: 27

Re: [SOLVED]Gnome-do refuses to work

uastasi wrote:

Gnome-do works after abs recompiling, but I can't install Files and Folders plugin on arch i686.
I have recompiled mono-addins with abs, then removed ~/.local/share/gnome-do/ folder but the problem still remains.
If I run gnome-do --debug on terminal this is the error message

Installing "Do.File,1.4" addin...
The following add-ins will be installed:
 - Files and Folders v1.4
Installing Files and Folders v1.4


Assembly not found: gconf-sharp, Version=2.20.0.0, Culture=neutral, PublicKeyToken=35e10195dab3c99f
WARNING: [Do.File,1.4] Could not load some add-in assemblies: The classes in the module cannot be loaded.

Any suggestions? roll

I just removed ~/.local/share/gnome-do and ~/.config/gnome-do before rebuilding on abs and  that plugin works for me, the only plugin that doesn't work for me is the session management, it gives me a dbus related error...

Offline

#6 2008-10-23 19:31:42

flowheat
Member
From: Pittsburgh, PA
Registered: 2008-09-23
Posts: 94

Re: [SOLVED]Gnome-do refuses to work

The session management plugin has been broke for me for a few months now.  There was some post on the gnome-do forums about it being fixed shortly but it never seems to have happened.

Offline

#7 2008-10-24 01:26:47

haTem
Member
Registered: 2008-10-24
Posts: 9

Re: [SOLVED]Gnome-do refuses to work

uorbe001 wrote:
uastasi wrote:

Gnome-do works after abs recompiling, but I can't install Files and Folders plugin on arch i686.
I have recompiled mono-addins with abs, then removed ~/.local/share/gnome-do/ folder but the problem still remains.
If I run gnome-do --debug on terminal this is the error message

Installing "Do.File,1.4" addin...
The following add-ins will be installed:
 - Files and Folders v1.4
Installing Files and Folders v1.4


Assembly not found: gconf-sharp, Version=2.20.0.0, Culture=neutral, PublicKeyToken=35e10195dab3c99f
WARNING: [Do.File,1.4] Could not load some add-in assemblies: The classes in the module cannot be loaded.

Any suggestions? roll

I just removed ~/.local/share/gnome-do and ~/.config/gnome-do before rebuilding on abs and  that plugin works for me, the only plugin that doesn't work for me is the session management, it gives me a dbus related error...

I'm getting the same error with the "Files and Folders" plugin. I've tried removing ~/.local/share/gnome-do and ~/.config/gnome-do before rebuilding gnome-do with abs, but I still get the error. Is there something else I have to rebuild?

Offline

#8 2008-10-25 22:31:58

uorbe001
Member
Registered: 2008-04-11
Posts: 27

Re: [SOLVED]Gnome-do refuses to work

flowheat wrote:

The session management plugin has been broke for me for a few months now.  There was some post on the gnome-do forums about it being fixed shortly but it never seems to have happened.

I had it working until last week, when I upgraded to gnome 2.24...

Offline

#9 2008-10-25 22:35:26

uorbe001
Member
Registered: 2008-04-11
Posts: 27

Re: [SOLVED]Gnome-do refuses to work

haTem wrote:

I'm getting the same error with the "Files and Folders" plugin. I've tried removing ~/.local/share/gnome-do and ~/.config/gnome-do before rebuilding gnome-do with abs, but I still get the error. Is there something else I have to rebuild?

Ops, now that I look at it, I can't get that plugin working either.... Hope they fix it on the next release hmm

Offline

#10 2008-10-29 00:59:56

Lord Illidan
Member
From: Malta
Registered: 2007-10-25
Posts: 248

Re: [SOLVED]Gnome-do refuses to work

Do you get Could not find PowerManagement on D-Bus. error on command line when trying to restart/shutdown? Oddly enough, suspend and hibernate still work!

Offline

#11 2008-11-07 23:13:34

uorbe001
Member
Registered: 2008-04-11
Posts: 27

Re: [SOLVED]Gnome-do refuses to work

Lord Illidan wrote:

Do you get Could not find PowerManagement on D-Bus. error on command line when trying to restart/shutdown? Oddly enough, suspend and hibernate still work!

Yeap, It's that same bug... and the "lock screen" works too...:/

Offline

Board footer

Powered by FluxBB