You are not logged in.
- Topics: Active | Unanswered
#26 2009-06-29 18:32:22
- chris_debian
- Member
- From: Wiltshire, UK
- Registered: 2009-02-24
- Posts: 284
Re: [SOLVED] wicd has me stumped!
Now I just need to work out how to put my rt61 into monitor mode, so I can test my other network...one step at a time.
Offline
#27 2009-06-29 18:59:28
- lifeafter2am
- Member
- From: 127.0.0.1
- Registered: 2009-06-10
- Posts: 1,332
Re: [SOLVED] wicd has me stumped!
Airmon-ng
Description
This script can be used to enable monitor mode on wireless interfaces. It may also be used to go back from monitor mode to managed mode. Entering the airmon-ng command without parameters will show the interfaces status.
Usage
usage: airmon-ng <start|stop> <interface> [channel]
Where:
<start|stop> indicates if you wish to start or stop the interface. (Mandatory)
<interface> specifies the interface. (Mandatory)
[channel] optionally set the card to a specific channel.
Or kismet will do it for you.
#binarii @ irc.binarii.net
Matrix Server: https://matrix.binarii.net
-------------
Allan -> ArchBang is not supported because it is stupid.
Offline
#28 2009-06-30 15:14:51
- chris_debian
- Member
- From: Wiltshire, UK
- Registered: 2009-02-24
- Posts: 284
Re: [SOLVED] wicd has me stumped!
Just installed Kismet. Will give it a go.
Cheers,
Chris.
Offline