You are not logged in.

#1 2010-05-09 17:54:36

McFlow
Member
Registered: 2010-04-17
Posts: 58

No temperatures with k10temp

Hello,
I have an AMD II X3 435 cpu. Sensors-detect successfully detects the k10temp module is needed.

Some south bridges, CPUs or memory controllers contain embedded sensors.
Do you want to scan for them? This is totally safe. (YES/no): y
Silicon Integrated Systems SIS5595...                       No
VIA VT82C686 Integrated Sensors...                          No
VIA VT8231 Integrated Sensors...                            No
AMD K8 thermal sensors...                                   No
AMD Family 10h thermal sensors...                           Success!
    (driver `k10temp')
AMD Family 11h thermal sensors...                           No
Intel Core family thermal sensor...                         No
Intel Atom thermal sensor...                                No
Intel AMB FB-DIMM thermal sensor...                         No
VIA C7 thermal sensor...                                    No
VIA Nano thermal sensor...                                  No

I also checked that it's loaded correctly.

[florian@errorkiste ~]$ lsmod |grep k10temp
k10temp                 2827  0

If I run sensors the output just tells:

[florian@errorkiste ~]$ sensors
k10temp-pci-00c3
Adapter: PCI adapter
temp1:       +21.0°C  (high = +70.0°C)

It's impossible that my CPU runs at 21°C. The bios reports something like 36°C.
Can somebody help me with this? smile

Last edited by McFlow (2010-05-09 17:54:54)

Offline

#2 2010-05-09 19:22:01

dcc24
Member
Registered: 2009-10-31
Posts: 732

Re: No temperatures with k10temp

Well, since the module loads successfully and it does report a temperature, it must be a problem inside k10temp. I would mention this in the lm-sensors mailing list.


It is better to keep your mouth shut and be thought a fool than to open it and remove all doubt. (Mark Twain)

My AUR packages

Offline

#3 2010-05-09 21:10:22

Skripka
Member
From: 2X1280X1024
Registered: 2009-02-19
Posts: 555

Re: No temperatures with k10temp

See the lm-sensors support page:
http://www.lm-sensors.org/wiki/Devices

Where it say RE:K10 support that:

wrote:

(2009-12-06) Embedded sensors are known to be unreliable on the DR-BA, DR-B2, DR-B3, RB-C2 and HY-D0 revisions of the family 10h CPU, which will never be supported. Driver contributed by Clemens Ladisch, reviewed by Jean Delvare.

Offline

Board footer

Powered by FluxBB