You are not logged in.
Pages: 1
Hi,
I am trying to run OpenWRT in VirtualBox to play around with it. I followed this wiki entry with no luck: http://wiki.openwrt.org/doc/howto/virtualbox
It always hangs at the same point:
br-lan: port 1(eth0) entering forwarding state
Regardless what network adapter or mode (bridged, NAT, etc..) I use, it is always the same.
So I wonder if this is related to my VirtualBox setup or some modules not being present? Other VMs are working fine (Arch, Windows XP, all using NAT for networking).
I have these modules in /etc/rc.conf
MODULES=(... vboxdrv vboxnetflt)
bridge-utils are also installed.
Thx for ideas.:)
Offline
Pages: 1