I had to go into rc.conf and put the usb modules, --ohci-hcd, uhci-hcd, usblp, then parport, and parport_pc. Then add cups to the Daemon section. Reboot and use the add printer in KDE and it worked! Getting closer and closer to dumping windows!! Thanks everybody --Larry
You gotta love linux!!
Why would you need parallel port and USB modules? Your printer can only be one or the other.
:? johnisevil -- I should take out the parport & parport_pc modules? -- Larry
If your printer is usb only you don't need parport and parport_pc modules.
The modules ohci-hcd and uhci-hcd are both for usb 1.1 (ehci-hcd is for usb 2.0). You probably want only one of them. Plus you need usblp. Also try using hwd for detecting hardware and modules.