You are not logged in.

#1 2005-02-22 02:30:05

lmellen
Member
From: Fairport, NY
Registered: 2004-06-11
Posts: 120

Printer now working!!!!!!!!!

big_smile I had to go into rc.conf and put the usb modules, --ohci-hcd, uhci-hcd, usblp, then parport, and parport_pc. Then add cups to the Daemon section. Reboot and use the add printer in KDE and it worked! Getting closer and closer to dumping windows!! Thanks everybody --Larry big_smile  big_smile
                                       You gotta love linux!!

Offline

#2 2005-02-22 08:24:37

johnisevil
Member
From: Hamilton, ON Canada
Registered: 2003-08-07
Posts: 221
Website

Re: Printer now working!!!!!!!!!

Why would you need parallel port and USB modules?  Your printer can only be one or the other.

Offline

#3 2005-02-24 01:46:47

lmellen
Member
From: Fairport, NY
Registered: 2004-06-11
Posts: 120

Re: Printer now working!!!!!!!!!

:? johnisevil -- I should take out the parport  &  parport_pc modules? -- Larry

Offline

#4 2005-02-24 09:50:01

lanrat
Member
From: Poland
Registered: 2003-10-28
Posts: 1,274

Re: Printer now working!!!!!!!!!

If your printer is usb only you don't need parport and parport_pc modules.
The modules ohci-hcd and uhci-hcd are both for usb 1.1 (ehci-hcd is for usb 2.0). You probably want only one of them. Plus you need usblp. Also try using hwd for detecting hardware and modules.

Offline

#5 2005-02-25 09:12:38

johnisevil
Member
From: Hamilton, ON Canada
Registered: 2003-08-07
Posts: 221
Website

Re: Printer now working!!!!!!!!!

johnisevil -- I should take out the parport & parport_pc modules? -- Larry

If it's a USB printer, you shouldn't need the parport modules.

Offline

Board footer

Powered by FluxBB