You are not logged in.

#1 2012-06-18 15:08:38

GhostIdentity
Member
Registered: 2012-06-18
Posts: 4

[SOLVED] Sound has disappeared - Arch + KDE + PulseAudio

It was working very much fine earlier. I don't know how it has vanished. The point that I gathered for reference are as follows:

1. The sound card is :

[bhoot@Mordor ~]$ lspci | grep Audio
00:14.2 Audio device: Advanced Micro Devices [AMD] nee ATI SBx00 Azalia (Intel HDA)
01:00.1 Audio device: Advanced Micro Devices [AMD] nee ATI RV710/730 HDMI Audio [Radeon HD 4000 series]

2. The backend to phonon is gstreamer with all the packages (good, bad and ugly) installed. I also tried phonon-vlc to no avail.

3. PulseAudio is installed currently on my system. The sound had disappeared before installing PulseAudio, though. I installed it in the hopes that it will bring back the sound, but in vain.

4. One thing worth mentioning is that there is not /etc/modprobe.d/alsa.conf file. Other posts concerning sound problems had mentioned this file.

5. alsamixer shows volume "100" in the only displayed channel "PulseAudio".

6. When I test the speaker settings, or the currently selected sound card from the Phonon settings, the test seems to go through, but no sound happens. I also tried aplay; no sound was produced again, even though the file had seemed to play successfully.

7. I also created a new user to see if anything changes. No sound in the new user account, too.

8. The currently settings in Phonon Settings are:

Audio Playback Device Order:
a. Built-in Audio Analog Stereo.
b. "RV710/730 HDMI Audio[Radeon HD 4000 Series] Digital Stereo (HDMI)
I tried preferring the HDMI one, to no avail.

So, any thoughts or solution to my problem?

Last edited by GhostIdentity (2012-06-19 18:04:31)

Offline

#2 2012-06-18 15:47:01

Odaer
Member
Registered: 2010-08-14
Posts: 87

Re: [SOLVED] Sound has disappeared - Arch + KDE + PulseAudio

PulseAudio dont fix a faulty installation of alsa. Begin with configure a working alsa enviroment. After that you  can install pulseAudio if you like.
Have you read this? https://wiki.archlinux.org/index.php/Ad … chitecture control indf
Maybe as you use phonon you could have some problem with kde use wrong device in the phonon configuration menu.

Last edited by Odaer (2012-06-18 16:01:36)

Offline

#3 2012-06-18 17:48:27

GhostIdentity
Member
Registered: 2012-06-18
Posts: 4

Re: [SOLVED] Sound has disappeared - Arch + KDE + PulseAudio

Odaer wrote:

PulseAudio dont fix a faulty installation of alsa. Begin with configure a working alsa enviroment. After that you  can install pulseAudio if you like.
Have you read this? https://wiki.archlinux.org/index.php/Ad … chitecture control indf
Maybe as you use phonon you could have some problem with kde use wrong device in the phonon configuration menu.

Holy Cow! As per your recommendations, I started going through the wiki, checking if everything is as desired. Some text in there suddenly made me wonder if I could hear the sound in headphones. I hadn't checked that. And voila! Its working through headphones.

Now, I have checked the laptop speakers in Windows 7. They are working perfectly. What would I have to do to bring back sound through them?

Offline

#4 2012-06-18 19:33:10

szorti
Member
From: Cracow, Poland
Registered: 2010-06-23
Posts: 21

Re: [SOLVED] Sound has disappeared - Arch + KDE + PulseAudio

You can try adding this line to your /etc/modprobe.d/modprobe.conf:

options snd-hda-intel model=MODEL

Where MODEL is name from this list:
HDA-Audio-Models
You can get your chip name with this command:

cat /proc/asound/card*/codec* | grep Codec

If You want to try different models and options without the need for reboot, try:

sudo rmmod -f snd-hda-intel
sudo modprobe snd-hda-intel model=xxx

You can also check my very similar (if not the same) problem:
https://bbs.archlinux.org/viewtopic.php?id=143572

Last edited by szorti (2012-06-18 19:39:54)

Offline

#5 2012-06-19 05:49:25

GhostIdentity
Member
Registered: 2012-06-18
Posts: 4

Re: [SOLVED] Sound has disappeared - Arch + KDE + PulseAudio

szorti wrote:

You can try adding this line to your /etc/modprobe.d/modprobe.conf:

options snd-hda-intel model=MODEL

Where MODEL is name from this list:
HDA-Audio-Models
You can get your chip name with this command:

cat /proc/asound/card*/codec* | grep Codec

If You want to try different models and options without the need for reboot, try:

sudo rmmod -f snd-hda-intel
sudo modprobe snd-hda-intel model=xxx

You can also check my very similar (if not the same) problem:
https://bbs.archlinux.org/viewtopic.php?id=143572


I did try that with $MODEL='laptop'; it didn't work, however.
Now that I know where to get the model names, I will try it as soon as I get home, and report back.

Offline

#6 2012-06-19 13:23:53

Lloople
Member
Registered: 2012-06-19
Posts: 2

Re: [SOLVED] Sound has disappeared - Arch + KDE + PulseAudio

I have a similar issue since I installed Arch, two days ago. I can listen with headphones but not from the speakers... This command "cat /proc/asound/card*/codec* | grep Codec" shows me this:

[lloople@lloople-dv6 ~]$ cat /proc/asound/card*/codec* | grep Codec
Codec: IDT 92HD75B3X5
Codec: ATI R6xx HDMI

And when I do a "lspci" I found two Audio entries:

00:1b.0 Audio device: Intel Corporation 82801I (ICH9 Family) HD Audio Controller
01:00.1 Audio device: Advanced Micro Devices [AMD] nee ATI RV710/730 HDMI Audio [Radeon HD 4000 series]

Does anyone knows how to enable audio in speakers? On Gnome 3 settings I cand choose between both, and when I choose the ATI RADEON output sound dissapears and reproduction speeds up, audio and video (even flash on YouTube)

Offline

#7 2012-06-19 18:03:29

GhostIdentity
Member
Registered: 2012-06-18
Posts: 4

Re: [SOLVED] Sound has disappeared - Arch + KDE + PulseAudio

I tried the following line in /etc/modprobe.d/modprobe.conf:

 options snd-hda-intel model=auto 

The sound is working now. :-)
I also re-installed PulseAudio after that. Its working flawlessly, too.

However, I would also like to mention that before I could check that setting, my system had got upgraded to a newer linux kernel. So, I can't be sure if that line was the real solution.

I am marking this thread as solved, anyways.

Thank you all for your help. smile

Last edited by GhostIdentity (2012-06-19 18:07:16)

Offline

Board footer

Powered by FluxBB