You are not logged in.

#1 2012-04-20 13:33:42

samson32
Member
Registered: 2012-03-31
Posts: 5

Wireless Problem Atheros AR9285 (ath9k)

Hi,
I try to connect with the Internet use these commends:

iwconfig wlan0 essid "The Kingdom Of The Marschall"
ifconfig wlan0 up
dhcpcd wlan0

and then

 
dhcpcd[2412]: version 5.5.6 starting
dhcpcd[2412]: wlan0: waiting for carrier
dhcpcd[2412]: timed out
dhcpcd[2412]: allowing 8 seconds for IPv4LL timeout
dhcpcd[2412]: timed out

I don't know what is wrong.

Some additional information

 
lspci -v
(...)
03:00.0 Network controller: Atheros Communications Inc. AR9285 Wireless Network Adapter (PCI-Express) (rev 01)
        Subsystem: AzureWave AW-NB037H 802.11bgn Wireless Half-size Mini PCIe Card [AR9002WB-1NGCD]
        Flags: bus master, fast devsel, latency 0, IRQ 17
        Memory at ddc00000 (64-bit, non-prefetchable) [size=64K]
        Capabilities: [40] Power Management version 3
        Capabilities: [50] MSI: Enable- Count=1/1 Maskable- 64bit-
        Capabilities: [60] Express Legacy Endpoint, MSI 00
        Capabilities: [100] Advanced Error Reporting
        Capabilities: [140] Virtual Channel
        Capabilities: [160] Device Serial Number 00-15-17-ff-ff-24-14-12
        Capabilities: [170] Power Budgeting <?>
        Kernel driver in use: ath9k
(...)


ifconfig wlan0
wlan0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500  metric 1
        ether 48:5d:60:f3:e7:57  txqueuelen 1000  (Ethernet)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0


dmesg |grep ath
[    3.753937] input: Razer DeathAdder as /devices/pci0000:00/0000:00:1d.0/usb3/3-1/3-1.4/3-1.4:1.0/input/input3
[    3.754087] generic-usb 0003:1532:0007.0003: input,hidraw2: USB HID v1.11 Mouse [Razer DeathAdder] on usb-0000:00:1d.0-1.4/input0
[    8.142723] ath: EEPROM regdomain: 0x60
[    8.142726] ath: EEPROM indicates we should expect a direct regpair map
[    8.142729] ath: Country alpha2 being used: 00
[    8.142730] ath: Regpair used: 0x60
[    8.160402] ieee80211 phy0: Selected rate control algorithm 'ath9k_rate_control'
[    8.160833] Registered led device: ath9k-phy0


uname -a
Linux myhost 3.3.2-1-ARCH #1 SMP PREEMPT Sat Apr 14 09:48:37 CEST 2012 x86_64 Intel(R) Core(TM) i7-2630QM CPU @ 2.00GHz GenuineIntel GNU/Linux 

I know about this problem https://bbs.archlinux.org/viewtopic.php?pid=1084982, but it couldn't concern me, because I've upgrade my system and now my kernel release is 3.3.2-1.

Offline

#2 2012-04-20 15:58:11

Gcool
Member
Registered: 2011-08-16
Posts: 1,456

Re: Wireless Problem Atheros AR9285 (ath9k)

Does it associate with your AP/router correctly (aka what does iwconfig show you)?


Burninate!

Offline

#3 2012-04-20 20:32:52

samson32
Member
Registered: 2012-03-31
Posts: 5

Re: Wireless Problem Atheros AR9285 (ath9k)

I've used wicd https://wiki.archlinux.org/index.php/Wicd it's resolved my problem.

Thank You.

iwconfig
lo        no wireless extensions.

wlan0     IEEE 802.11bgn  ESSID:off/any  
          Mode:Managed  Access Point: Not-Associated   Tx-Power=16 dBm   
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Power Management:off
          
eth0      no wireless extensions.

Offline

#4 2012-04-20 20:50:51

Gcool
Member
Registered: 2011-08-16
Posts: 1,456

Re: Wireless Problem Atheros AR9285 (ath9k)

Good to hear you've resolved it.

Don't forget to mark your thread as [SOLVED].


Burninate!

Offline

Board footer

Powered by FluxBB