You are not logged in.
Pages: 1
Topic closed
When I installed Arch on my laptop, I made the mistake of separating my / and /home directories, so today I finally made a full backup, deleted the 2 partitions and created a new one, and restored the backup. Then I edited my menu.lst to use the new partition's UUID, and did the same for fstab. Now when I boot, GRUB just sits for a while, and then it brings me to a tty that says
Arch Linux 3.4.4-2-ARCH (tty1)
(none) Login:I don't know where to go from here, so any help would be greatly appreciated.
Last edited by Sotanaht (2012-08-31 02:07:55)
Offline
What Install image did you use?
Are you able to login to your root account?
Offline
What Install image did you use?
Are you able to login to your root account?
I used an ArchBang image. I've decided to just do a fresh ArchLinux install, because ArchBang isn't worth it if they're going to lag behind ArchLinux.
Should I mark this thread as "Not going to be solved" or something?
Offline
You better check the Archbang forums.
Offline
There's no such thing as a stupid question, but there sure are a lot of inquisitive idiots !
Offline
Pages: 1
Topic closed