You are not logged in.

#1 2012-08-28 21:19:05

Sotanaht
Member
Registered: 2012-01-14
Posts: 29

Can't get to a shell after repartitioning [I gave up, move along]

When I installed Arch on my laptop, I made the mistake of separating my / and /home directories, so today I finally made a full backup, deleted the 2 partitions and created a new one, and restored the backup.  Then I edited my menu.lst to use the new partition's UUID, and did the same for fstab.  Now when I boot, GRUB just sits for a while, and then it brings me to a tty that says

Arch Linux 3.4.4-2-ARCH (tty1)

(none) Login:

I don't know where to go from here, so any help would be greatly appreciated.

Last edited by Sotanaht (2012-08-31 02:07:55)

Offline

#2 2012-08-29 19:02:14

hadrons123
Member
From: chennai
Registered: 2011-10-07
Posts: 1,249

Re: Can't get to a shell after repartitioning [I gave up, move along]

What Install image did you use?

Are you able to login to your root account?

Offline

#3 2012-08-30 19:47:42

Sotanaht
Member
Registered: 2012-01-14
Posts: 29

Re: Can't get to a shell after repartitioning [I gave up, move along]

hadrons123 wrote:

What Install image did you use?

Are you able to login to your root account?

I used an ArchBang image.  I've decided to just do a fresh ArchLinux install, because ArchBang isn't worth it if they're going to lag behind ArchLinux.

Should I mark this thread as "Not going to be solved" or something?

Offline

#4 2012-08-31 00:35:47

hadrons123
Member
From: chennai
Registered: 2011-10-07
Posts: 1,249

Re: Can't get to a shell after repartitioning [I gave up, move along]

You better check the Archbang forums.

Offline

#5 2012-08-31 18:54:23

Inxsible
Forum Fellow
From: Chicago
Registered: 2008-06-09
Posts: 9,183

Re: Can't get to a shell after repartitioning [I gave up, move along]


Forum Rules

There's no such thing as a stupid question, but there sure are a lot of inquisitive idiots !

Offline

Board footer

Powered by FluxBB