You are not logged in.
- Topics: Active | Unanswered
#1 2012-10-29 22:50:48
- filam
- Wiki Maintainer
- From: Portland, ME
- Registered: 2008-04-11
- Posts: 158
- Website
Connecting to the WebUI of a Linksys WAP54G
I am trying to setup a Linksys Wireless-G Access Point (WAP) as a repeater to boost the signal of a wireless router (see: Configuring an Access Point as a Wireless Repeater). Unfortunately, I can't access the WebUI of the WAP.
I connected my laptop to the WAP using an Ethernet cable. The lights on the WAP were all on (i.e. Power, red; Act, green; Link, orange) and none were blinking. I repeated the same steps with several Ethernet cables.
I created a Gist, Connecting to a wireless access point, which is a record of my attempt to connect to the device. Am I missed something obvious?
Offline
#2 2012-10-30 00:04:19
- WonderWoofy
- Member
- From: Los Gatos, CA
- Registered: 2012-05-19
- Posts: 8,414
Re: Connecting to the WebUI of a Linksys WAP54G
I think this is not an issuea with Arch linux here... or Linux in general... or even the computer itself... you may want to be asking cisco.
Offline
#3 2012-10-31 10:40:05
- filam
- Wiki Maintainer
- From: Portland, ME
- Registered: 2008-04-11
- Posts: 158
- Website
Re: Connecting to the WebUI of a Linksys WAP54G
I think this is not an issuea with Arch linux here... or Linux in general... or even the computer itself... you may want to be asking cisco.
Thanks WW, that's what I was thinking. I just wanted to make sure I wasn't making a mistake since I hadn't used the `ip` commands before.
Offline