You are not logged in.
- Topics: Active | Unanswered
Pages: 1
Topic closed
#1 2013-03-25 12:20:11
- Aegidius
- Member
- From: Italy
- Registered: 2011-06-29
- Posts: 288
- Website
Ruby on Rails: command not found
Hello! 
I installed Ruby on rails with the command sudo gem install rails --no-ri --no-rdoc. In Aptana Studio 3 I try to create a new Rails project but in the IDE terminal I see the error bash: rails: command not found.
What is the problem?
Offline
#2 2013-03-25 12:28:43
- Raynman
- Member
- Registered: 2011-10-22
- Posts: 1,539
Re: Ruby on Rails: command not found
I guess rails is not anywhere in your PATH. I'm not familiar with gems, but you should find out where rails was installed and either make sure that directory is in your PATH (by adding it in ~/.bashrc) or set the full path to rails in the Aptana IDE.
Offline
#4 2013-03-25 13:48:17
- WorMzy
- Administrator
- From: Scotland
- Registered: 2010-06-16
- Posts: 13,588
- Website
Re: Ruby on Rails: command not found
Sakura:-
Mobo: MSI MAG X570S TORPEDO MAX // Processor: AMD Ryzen 9 5950X @4.9GHz // GFX: AMD Radeon RX 5700 XT // RAM: 32GB (4x 8GB) Corsair DDR4 (@ 3000MHz) // Storage: 1x 3TB HDD, 6x 1TB SSD, 2x 120GB SSD, 1x 275GB M2 SSD
Making lemonade from lemons since 2015.
Offline
#5 2013-03-25 14:18:53
- Inxsible
- Forum Fellow
- From: Chicago
- Registered: 2008-06-09
- Posts: 9,183
Re: Ruby on Rails: command not found
Follow discussion in the linked thread.
Closed...
There's no such thing as a stupid question, but there sure are a lot of inquisitive idiots !
Offline
Pages: 1
Topic closed