You are not logged in.

#1 2013-05-15 08:41:42

3000
Member
Registered: 2013-01-18
Posts: 44

Multiple Profiles with new netctl

Hi guys, I couldn't manage to configure my network. I really need your help.

I have a fresh Installation with netctl. One profile works without any issues. But I use XEN and need to bridge my Network. In addition I like to have static ip addresses for both profiles.

According to ArchWiki I have to netctl disable <profile> if I plan to use more than one profile and use the command systemctl enable netctl-ifplugd@<interface>.service to use multiple profiles. I have two interfaces: eno1 for regular ethernet-static and xenbr0 for bridge. So I need to enable both right?

Plus I edited /etc/ifplugd/ifplugd.conf in line with INTERFACES="eno1 xenbr0". I didn't edit line ARGS="-fwI -u0 -d10".

What am I doing wrong? thanks for your help!

Offline

#2 2013-05-15 11:27:37

3000
Member
Registered: 2013-01-18
Posts: 44

Re: Multiple Profiles with new netctl

do I even need to set up multiple profiles if I "just" have to bridge the Network?

Last edited by 3000 (2013-05-15 11:27:49)

Offline

#3 2013-09-20 09:23:45

funny
Member
Registered: 2008-01-28
Posts: 44

Re: Multiple Profiles with new netctl

J have the same problem. Do you solve this problem?

Offline

#4 2013-09-20 10:02:43

tomk
Forum Fellow
From: Ireland
Registered: 2004-07-21
Posts: 9,839

Re: Multiple Profiles with new netctl

There's a template for a bridge profile in /etc/netctl/examples, did you try it?

Offline

Board footer

Powered by FluxBB