You are not logged in.
- Topics: Active | Unanswered
#1 2013-05-15 08:41:42
- 3000
- Banned
- Registered: 2013-01-18
- Posts: 47
Multiple Profiles with new netctl
Hi guys, I couldn't manage to configure my network. I really need your help.
I have a fresh Installation with netctl. One profile works without any issues. But I use XEN and need to bridge my Network. In addition I like to have static ip addresses for both profiles.
According to ArchWiki I have to netctl disable <profile> if I plan to use more than one profile and use the command systemctl enable netctl-ifplugd@<interface>.service to use multiple profiles. I have two interfaces: eno1 for regular ethernet-static and xenbr0 for bridge. So I need to enable both right?
Plus I edited /etc/ifplugd/ifplugd.conf in line with INTERFACES="eno1 xenbr0". I didn't edit line ARGS="-fwI -u0 -d10".
What am I doing wrong? thanks for your help!
Offline
#2 2013-05-15 11:27:37
- 3000
- Banned
- Registered: 2013-01-18
- Posts: 47
Re: Multiple Profiles with new netctl
do I even need to set up multiple profiles if I "just" have to bridge the Network?
Last edited by 3000 (2013-05-15 11:27:49)
Offline
#3 2013-09-20 09:23:45
- funny
- Member
- Registered: 2008-01-28
- Posts: 44
Re: Multiple Profiles with new netctl
J have the same problem. Do you solve this problem?
Offline
#4 2013-09-20 10:02:43
- tomk
- Forum Fellow
- From: Ireland
- Registered: 2004-07-21
- Posts: 9,839
Re: Multiple Profiles with new netctl
There's a template for a bridge profile in /etc/netctl/examples, did you try it?
Offline