You are not logged in.

#1 2013-07-27 01:18:48

endtroducing
Member
From: Montreal, Quebec
Registered: 2007-02-22
Posts: 10

D-Link DWA 556 pci-e (ath9k driver)

Hi,

I get the following error at boot time for my wireless PCI card.

dmesg:

[    2.939201] ath9k 0000:03:00.0: Refused to change power state, currently in D3
[    3.046660] ath: phy0: Couldn't reset chip
[    3.046682] ath: phy0: Unable to initialize hardware; initialization status: -5
[    3.046711] ath9k 0000:03:00.0: Failed to initialize device
[    3.047215] ath9k: probe of 0000:03:00.0 failed with error -5

lspci:

03:00.0 Network controller: Qualcomm Atheros AR5418 Wireless Network Adapter [AR5008E 802.11(a)bgn] (PCI-Express) (rev ff)

I have tried to unload and reload ath9k. Here is what dmesg sends me:

[14058.227177] ath9k: ath9k: Driver unloaded
[14080.385921] ath9k 0000:03:00.0: Refused to change power state, currently in D3
[14080.488253] ath: phy2: Couldn't reset chip
[14080.488256] ath: phy2: Unable to initialize hardware; initialization status: -5
[14080.488257] ath9k 0000:03:00.0: Failed to initialize device
[14080.488523] ath9k: probe of 0000:03:00.0 failed with error -5

Does anyone know what could be done to resolve this?

Thanks,

end.

Offline

#2 2013-07-29 11:24:26

fukawi2
Ex-Administratorino
From: .vic.au
Registered: 2007-09-28
Posts: 6,231
Website

Re: D-Link DWA 556 pci-e (ath9k driver)

Moving to Networking, Server, and Protection

Offline

#3 2013-07-29 17:11:50

endtroducing
Member
From: Montreal, Quebec
Registered: 2007-02-22
Posts: 10

Re: D-Link DWA 556 pci-e (ath9k driver)

I am using the arch stock kernel (3.10.2)

Something else I have done is  rmmod ath9k and modprobe the ath5k driver but the card still does not spawn.

I will see if blacklisting the ath9k driver and adding ath5k to mkinitcpio.conf fix the issue.

Offline

#4 2013-07-29 23:01:14

WonderWoofy
Member
From: Los Gatos, CA
Registered: 2012-05-19
Posts: 8,414

Re: D-Link DWA 556 pci-e (ath9k driver)

There is a new kernel in the repos (3.10.3).  Maybe you should update and then re-report just to ensure that you are seeking advice on what is currently in the repos.

Offline

Board footer

Powered by FluxBB