[SOLVED] Configure LACP (802.3ad) Bond

Hrast · 2014-09-02 03:31:39

I've set this up before on Debian and RHEL/CentOS, but I'm having zero luck under Arch. I get the interfaces bound, and I get a bond0, but its always round-robin. My /etc/modprobe.d/bonding.conf has this one line: options bonding mode=4 miion=100.

All the references I can find to bonding in Arch are for wired/wireless failover, has anyone got this to work?

Thanks.

Last edited by Hrast (2014-09-05 02:37:21)

fukawi2 · 2014-09-02 04:32:11

Hrast wrote:

options bonding mode=4 miion=100

Assuming it's a typo, but just in case... It's "miimon", not "miion"

Are you using netctl? Share your /etc/network.d/ profile. Have you tried "mode=802.3ad" instead of "mode=4"? It shouldn't make a difference, but it might help show any problems.

Hrast · 2014-09-05 02:36:08

Yep, it was a typo, and since I copied and pasted it, it was that way in the file too. *bangs head on desk multiple times* Once corrected, its worked just fine. This has been happening way too often to me lately, ugh.

fukawi2 · 2014-09-05 02:38:17

Sometimes it is simple things like having another set of eyeballs to solve a problem. Half the threads I start in forums don't even get posted because writing them out methodically highlighted the solution

Arch Linux

#1 2014-09-02 03:31:39

[SOLVED] Configure LACP (802.3ad) Bond

#2 2014-09-02 04:32:11

Re: [SOLVED] Configure LACP (802.3ad) Bond

#3 2014-09-05 02:36:08

Re: [SOLVED] Configure LACP (802.3ad) Bond

#4 2014-09-05 02:38:17

Re: [SOLVED] Configure LACP (802.3ad) Bond

Board footer