Arch Linux

elbeast2017

Member

Registered: 2017-12-12

Posts: 1

dot1x authentication not working via network manager.

Dears ,

After installing Arch, i used 802.1x authentication for a while and it was working fine. recently it is stuck at configuring the interface.  This is what i see in the logs:

Dec 12 09:17:49 archy NetworkManager[8839]: <info>  [1513063069.1255] device (enp0s31f6): state change: config -> need-auth (reason 'none', sys-iface-state: 'managed')
Dec 12 09:17:49 archy NetworkManager[8839]: <warn>  [1513063069.1346] device (enp0s31f6): Activation: (ethernet) asking for new secrets
Dec 12 09:17:49 archy NetworkManager[8839]: <info>  [1513063069.1671] device (enp0s31f6): state change: need-auth -> prepare (reason 'none', sys-iface-state: 'managed')
Dec 12 09:17:49 archy NetworkManager[8839]: <info>  [1513063069.1676] device (enp0s31f6): state change: prepare -> config (reason 'none', sys-iface-state: 'managed')
Dec 12 09:17:49 archy NetworkManager[8839]: <info>  [1513063069.1681] device (enp0s31f6): Activation: (ethernet) connection 'Wired connection 1' requires no security. No secrets needed.
Dec 12 09:17:49 archy NetworkManager[8839]: <info>  [1513063069.2412] device (enp0s31f6): supplicant interface state: starting -> ready
Dec 12 09:17:49 archy NetworkManager[8839]: <info>  [1513063069.2486] device (enp0s31f6): supplicant interface state: ready -> associated

It is complaining that there are no secrets. I'm using Plasma and putting the password there but seems Network manager is unable to access it. Any idea what could be the reason?

PEAP is used with mschapv2 as an inner auth.

elbeast.

V1del

Forum Moderator

Registered: 2012-10-16

Posts: 21,672

Re: dot1x authentication not working via network manager.

Does a manual reconnect work (i.e. clicking connect manually in the plasma widget, instead of relying on the autoconnect)? Likely same problem as https://bbs.archlinux.org/viewtopic.php?id=232311