You are not logged in.
When I try to add a new vpn connection with NetworkManager, I get the following error (and the save button is greyed out):
Cannot save connection due to error: Invalid setting VPN: IPSec gateway
My libraries:
- nm-connection-editor 1.24.0-1
- networkmanager: 1.36.2-1.0
- linnm: 1.36.2-1.0
- networkmanager-vpnc: 1.2.8-1
Last edited by MSco (2022-05-05 10:35:41)
Offline
Got the same problem (VPNC for fritzbox).
Solved it by adding the tunnel Interface name (tun0):
1. On the VPN tab, there is an "Advanced" button.
2. In the advanced settings, there is a setting: "Tunnel Interface Name" under section "Transport and security". Enter "tun0" here.
3. Fill out settings as normal and you're good to go.
Notes: I used nm-connection-editor for this.
I also installed Strongswan, but I don't think this is related.
And there is a similar post on the German forum site: forums.archlinux.de, if i'm correct. Maybe someone can add this to that site? (My german isn't that stellar...)
Offline
@Bubbel
Great, thank you! This solved my issue!
Thank you very much!
Offline
You're very welcome. Please mark this thread as solved, so the solution is easier to find.
Offline