You are not logged in.
Hi!
I cannot connect on boot because netcfg2 dont recognize the status of my eth0 interface the problem is the output of ip.
ip link show eth0
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UNKNOWN qlen 1000
link/ether 00:22:64:6e:bd:6f brd ff:ff:ff:ff:ff:ff
It is not show as UP but as UNKNOWN, I dont know why. If I disconnect the cable and connect again it show as UP.
Someone know why it show as UNKNOWN?
Thanks
Offline