You are not logged in.

#26 2010-04-25 13:14:25

Surgat_
Member
Registered: 2007-08-08
Posts: 317

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

You must make sure that grub supports it too

Offline

#27 2010-04-25 13:26:24

Ultraman
Member
Registered: 2009-12-24
Posts: 242

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

Wouldn't a separate /boot formatted as ext2 (or another filesystem GRUB supports) fix that?

Last edited by Ultraman (2010-04-25 13:26:45)

Offline

#28 2010-04-25 16:18:33

tpowa
Developer
From: Lauingen , Germany
Registered: 2004-04-05
Posts: 2,322

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

Yes no bootloader supports btrfs out of the box right now. You need an extra /boot for it.
As said if btrfs is used for / you need to format the partition you need and use it as mountpoint.
If you use fancy mounting like subdomains etc. it will not work, then you need to mount everything by hand to /tmp/install.
You need to tweak imknitcpio.conf too for getting the crc32 modules in there too else it should work just fine.
I plan btrfs support for next release so stay tuned for next release in next weeks.

Offline

#29 2010-04-26 15:44:56

fflarex
Member
Registered: 2007-09-15
Posts: 466

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

Shouldn't LILO work fine with btrfs?

Offline

#30 2010-04-27 05:14:04

tpowa
Developer
From: Lauingen , Germany
Registered: 2004-04-05
Posts: 2,322

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

Hrm if you want to try with lilo go ahead, i'm happy about any feedback before writing btrfs support.
In theory i would say lilo could work because it doesn't know anything about filesystems.

Offline

#31 2010-04-29 17:15:21

barkat1407
Member
Registered: 2010-04-15
Posts: 5

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

Can u put "Set up Network" before clock setting .

as in official install disk. So time sync can go right.

Just a suggestion , it's convinent this way.

Offline

#32 2010-04-30 08:45:22

venky80
Member
Registered: 2007-05-13
Posts: 1,002

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

so this image doesnt support brtfs?


Acer Aspire V5-573P Antergos KDE

Offline

#33 2010-04-30 12:10:35

tpowa
Developer
From: Lauingen , Germany
Registered: 2004-04-05
Posts: 2,322

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

venky it has the utils in the ramfs, you need to configure your system correct.
The installer itself doesn't know anything about btrfs.
You can create filesystem in a separate console.
You need to adjust initcpio.conf and fstab correct and use a bootloader that boot from a none btrfs filesystem.

Offline

#34 2010-05-06 12:28:28

goran'agar
Member
From: Nothern Italy
Registered: 2009-05-19
Posts: 171

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

FWIW, with this image I've been able to boot my encrypted eeepc, unlock the rootvolume, backup the rootfs, format the rootfs as btrfs, restore from the backup just created.

All is fine so far. Many thanks!


Sony Vaio VPCM13M1E  - Arch Linux - LXDE

Offline

#35 2010-05-11 17:02:31

kernelOfTruth
Member
From: Vienna, Austria
Registered: 2010-05-11
Posts: 20

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

thank you very much tpowa !

that release was very helpful in getting my Arch System to run (the official 2009.08 liveCD wouldn't work since 2.6.30 doesn't support my network adapter)


Hardcore Linux user since 2004 big_smile

Offline

#36 2010-05-18 07:34:40

baka
Member
Registered: 2010-05-18
Posts: 11

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

when can we hope for next release .

Offline

#37 2010-05-18 20:59:57

tpowa
Developer
From: Lauingen , Germany
Registered: 2004-04-05
Posts: 2,322

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

guess, what i say, when it's ready, at the moment i'm fighting with some changes i made to setup code.
New image will contain:
- some lvm/grub2 fixes
- some more device listing fixes(for some uncommon devices, like cciss,ida,rd and mmcblk)
- automatic activation of complex devices in setup (eg. lvm, raid, dmraid)
-Packages are frozen and will include:
  bump lts kernel to 2.6.32 series, kernel .2.6.34

Delayed for next release:
- btrfs integration

so I hope I get this done in next 2 days, I cannot promise anything though.

Last edited by tpowa (2010-05-18 21:01:34)

Offline

#38 2010-05-21 06:52:05

tpowa
Developer
From: Lauingen , Germany
Registered: 2004-04-05
Posts: 2,322

Re: 2010.04-1 archboot "2k10-R3" ISO hybrid image released

Ok new images are syncing to the servers, please continue here:
http://bbs.archlinux.org/viewtopic.php?id=97527

Offline

Board footer

Powered by FluxBB