You are not logged in.
Hello, I have a network card integrated in my motherboard. So I want to Wake On Lan for my sis190.
But I had read the wiki. https://wiki.archlinux.org/index.php/Wol But not working.
# pacman -S ethtool
isn't wake option.
and /sys/class/net/eth0/device/power/wakeup disabled. If I get write access for everybody and I change for enable, and disable write access, and I hibernate or shutdown my arch, I can't wakeup on lan, from another comp, and enable changed to disable. Why?
But If I shutdown or hibernate from windows I can wake up.
So I'm interesting how can I get wake on lan for my sis190 network chip?
$ sudo ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Link partner advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Link partner advertised pause frame use: No
Link partner advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Current message level: 0x00000037 (55)
drv probe link ifdown ifup
Link detected: yes
Thanks.
I wait for your useful answer.
Last edited by gyurman (2011-04-02 15:04:13)
Offline
Hello, where can I send this for error report? Can you link here page for kernel error repot? Is it that?
Offline
Hello,
I still up this. So I need wake on lan for mine sis191. But linux use sis190 module. Why?
How can I get wake on lan for my card?
Offline