Arch Linux

DrKillPatient

Member

Registered: 2011-07-28

Posts: 85

New router, new error

My 2WIRE router broke yesterday and it's been replaced with a new (although identical) one. Now, when booting my fairly fresh copy of Arch (64-bit), it prints this:

e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: None
e1000e 0000:00:19.0:eth0: 10/100 speed: disabling TSO

My connection consists of an ethernet cable going straight from the router to the desktop. I don't remember seeing it before on the previous router, and my internet seems to be working normally as of now. However, does this message indicate any significant error that I'm unaware of at this point? If so, how should I fix it?

Last edited by DrKillPatient (2011-08-04 00:04:20)

karol

Archivist

Registered: 2009-05-06

Posts: 25,440

Re: New router, new error

https://bbs.archlinux.org/viewtopic.php?id=123597